No Sew (Almost) Faux Roman Shade!
After seeing many pictures and thoughts of this "faux roman shade" and deciding it really didn't look THAT hard... i took my own stab at making one!
Of course, I completely forgot to take pictures "during" the making so all I have are the "after" pictures.
1. I started with my base fabric, by cutting it twice the length I wanted it to hang. EX: I wanted mine to hang from the top of the window at 16" down.... So I cut my fabric to be 32" long. Then I measured the width of the window and added 3 inches for the seams on the ends.
2. Stich-Witchery....heard of it?? You can buy at your local hobby lobby ;). Making sure to only fold over 1.5" of either side of the width, place the piece of stitch witchery in between the fold to create the seams around the edges of the fabric. Using an iron.. steam all edges by holding down the iron for 10 seconds, move over and do again. Repeat this until you have created seams all the way around the rectangle fabric.
3. I wanted to add a ribbon banding, so I used the stitch witchery to iron the navy banding in the pattern I wanted.
4. Use pins to tuck your fabric in a folded pattern and pin securely. Leave about 3 " at the top for the mounting. Pin on pin in the center of the shade and one on each end of EACH fold you have created.
5. Then using a needle and thread, make one or two small sews to hold where the pin is. Remove the pins and the fabric and fold should stay in place!
6. I "ghetto" rigged my mounting of these guys ;) I popped off the wood frame on the top of my wood blinds and duck-taped the shade to the back of it and then popped it right back onto the wood blinds frame!
Saved time and holes in my wall ;)
I'm excited about the turn out!
Here you can see where I've pinned each fold...
These will coordinate well with my new drapes coming in this week! Stay tuned ;)












































